Table of Contents
Select Wi-Fi Client mode
Fixture
- A Wi-Fi hotspot, called Brian for this test
- A workstation (laptop) connected to the Brian Wi-Fi hotspot
- Two devices A B with Release Candidate installed and running, set up with the following Phone Numbers and Names:
- 55501 TestA
- 55502 TestB
- Ensure each device A and B is disconnected:
- Go to Serval main screen → Connect
- Ensure Enable Services is OFF (un-check the checkbox if necessary)
- Turn Auto Cycle to OFF (un-check the checkbox)
- Go to peer list: Serval main screen → Contacts → List Phones On The Mesh)
- Ensure the peer list is empty
Test
- On each device A and B:
- Go to Serval main screen → Connect
- ASSERT Network called Brian appears in list, subtitled Open or Secured
- Select the Brian network
- ASSERT Device associates as client of Brian network and is reachable from the workstation, eg, using the ping command
- On Device A (in Client mode):
- Go to peer list screen: Serval main screen → Contacts → List Phones On The Mesh
- ASSERT Peer list contains entry for 55502 TestB
- On Device B (in Client mode):
- Go to peer list screen: Serval main screen → Contacts → List Phones On The Mesh
- ASSERT Peer list contains entry for 55501 TestA
- On device A, call device B: press 55502 TestB Call icon (green telephone)
- ASSERT Device B rings and displays Incoming call screen
Clean up
- EITHER On device A press End Call. Any failure in this process should be reported under the test case:
- OR On device B press Decline. Any failure in this process should be reported under the test case: