Table of Contents
Select Wi-Fi Access Point mode
Fixture
- Three devices A B C with Release Candidate installed and running, set up with the following Phone Numbers and Names:
- 55501 TestA
- 55502 TestB
- 55503 TestC
- Ensure each device A B and C is disconnected:
- Go to Serval main screen → Connect
- Ensure Enable Services is OFF (un-check the checkbox if necessary)
- Turn Auto Cycle to OFF (un-check the checkbox)
- Go to peer list: Serval main screen → Contacts → List Phones On The Mesh)
- Ensure the peer list is empty
Test
- On device A:
- Go to Serval main screen → Connect
- select the ap.servalproject.org HotSpot network
- if a warning dialog pops up, press the Connect button
- ASSERT After a few seconds, the ap.servalproject.org network is marked as On
- ASSERT All client networks (Open and Secured) disappear, replaced by Wi-Fi entry marked Off
- On each device B and C, associate as client of device A:
- Go to Serval main screen → Connect
- ASSERT A network called ap.servalproject.org Open appears in the list
- Select network ap.servalproject.org Open
- ASSERT After a few seconds, ap.servalproject.org Open network is marked as Connected
- ASSERT Device A appears in peer list: Serval main screen → Contacts → List Phones On The Mesh contains entry for 55501 TestA
- ASSERT On device A, devices B and C both appear in peer list: Serval main screen → Contacts → List Phones On The Mesh contains entries for 55502 TestB and 55503 TestC
- On device A, call device B: press 55502 TestB Call icon (green telephone)
- ASSERT Device B rings and displays Incoming call screen
Clean up
- EITHER On device A press End Call. Any failure in this process should be reported under the test case:
- OR On device B press Decline. Any failure in this process should be reported under the test case: