Differences

This shows you the differences between two versions of the page.

Link to this comparison view

content:getstarted [21/08/2017 11:26]
Robin Bonnin
content:getstarted [21/08/2017 11:28] (current)
Robin Bonnin
Line 54: Line 54:
  
 Your cable should work now.  Your cable should work now. 
-You can try connect it on your computer and see if it is recognized : <code>ls usbs</code>+You can try connect it on your computer and see if it is recognized : <code>lsusb</code>
  
  
Line 95: Line 95:
 You should see the device booting. You should see the device booting.
   *Connect the ethernet port of the mesh to your computer and set the IP to 192.168.1.2.   *Connect the ethernet port of the mesh to your computer and set the IP to 192.168.1.2.
-  * ** This is now the tricky part, you have 2 seconds to type <code>gl</code> to interrupt the boot **+  * ** This is now the tricky part, you have 2 seconds to type ''gl'' to interrupt the boot **
     * If the boot interrupt doesn't work, it means that the USB port doesn't allow to pass character.     * If the boot interrupt doesn't work, it means that the USB port doesn't allow to pass character.
     * To resolve that, make sure that the the minicom set up is correctly done, especially that Hardware flow Control is disabled     * To resolve that, make sure that the the minicom set up is correctly done, especially that Hardware flow Control is disabled

Login